NanoStation Loco M2

NanoStation Loco M2 is a compact outdoor unit which includes 2 x 8 dBi antenna (MIMO) for the 2.4 GHz band. The unit allows real communication speed up to 150 Mbps.
Another big advantage is (with addition to high transfer speeds thank to the 802.11n standard) the TDMA Time Division Multiplexing which enables to connect. This product also has a low latency.
Compared to two predecessors NanoStation M2 Loco has a stronger processor clocked at 400 MHz and bigger memory.
Web administration is very simple and transparent. Here are a few examples of what can be set:

• AP mode, client or WDS
• Traffic Shaping
• QoS
• transparent bridge or routing between WAN and LAN, without NAT or NAT
• trength of the signal, which shall correspond to specific signaling LED
• Output power to 23 dBm

The device supports transparent IPv6 transfers in the bridge and WDS mode.
The package also consists of the 24 V PoE power source, which contains a reset button.
You can use it for switching the device to the TFTP firmware recovery mode.
Another advantage is PoE support on the second Ethernet port for direct supply of another device. This feature can be disabled via the software adjustment.
Important information on compatibility:

• This device uses a new firmware AirOS V. For this reason, it is possible
• that the device is not fully compatible with other radio devices.
• You can check the suitability by contacting us via tech@i4wifi.cz.
• AirOS The system is constantly being improved and therefore ew recommend to always use the current version.